Scubapro Mark 2 EVO DIN Regulator, First Stage

Classic downstream piston- The Mark 2 EVO DIN is the best example of bulletproof reliability and trouble-free, minimum maintenance regulators. The classic downstream piston configuration is the simplest mechanism that exists to control the pressure drop from a tank to feed the second stage. The classic downstream valve is the first choice of diving centers and rental facilities worldwide for warm and moderate water temperatures. Classic downstream valves are particularly noted for their legendary safety and reliability. When in use, the downstream valve opens in the same direction as the incoming air flow. To close the valve and stop the air flow, a spring counteracts the force of the incoming air. Therefore, a certain inhalation effort is always required to overcome the spring tension and open the valve.

This first stage epitomizes reliability and simplicity. Its standard Flow-By-Piston design is ideal for divers who don’t want to get bogged down with an overwhelming amount of bits and pieces, but still want the peace of mind that comes with a sound piece of equipment. This first stage is equipped with Scubapro’s Extended Thermal Insulating System (XTIS), which will keep your first stage functioning properly, even in frigid water. The New Scubapro MK2 EVO DIN first stage regulator meets the new EN250-2014 requirements for cold water diving, CE approved for 3360psi (230 bars). This model go even beyond this super stringent qualification and have successfully been tested in extreme cold diving conditions at less than 36.7°F (2.6°C).

The freezing resistance has been increased by 50% over the previous MK2 regulator first stage. Scubapro has achieved this with some new design features. The new MK2 EVO DIN has a proprietary insulating coating on key internal components that resist the cooling effect found in previous MK2 first stage regulators, also as a specific anti-freezing measure; Scubapro engineers have designed a patented finned cap with ribs for the MK2 EVO DIN first stages for optimal-cold water diving. The ribs of the XTIS act as a radiator to increase the surface area of heat transfer from the water to warm up the internal parts that have been drastically cooled down by the gas pressure drop. The new MK2 EVO DIN has a bigger body and cap thread, new body insulating bushing, spring isolating coating, removable HP orifice and larger opening on the cap. The MK2 has one 7/16″ threaded high-pressure port and four 3/8″ threaded low-pressure ports. The first stage body is manufactured from marine-grade chrome plated brass and weighs 17.1 oz. (485 g).

Scubapro Mark 2 EVO Features

• Scubapro Mark 2 EVO DIN Regulator:
• Flow-By Piston Design
• Marine Grade Chromed Brass Body and Components
• Compact and Lightweight
• Weight: 17.1 oz. (485 g)
• 4 LP Ports, 3/8″ Threaded
• 1 HP Port 7/16″ Threaded
• Fail-Safe Downstream Valve
• EVO: Means Evolution, Revolutionizing Existing Technologies to Higher Performance
• High Performance in Warm and Cold Water
• Meets New EN250-2014 Requirements
• CE Approved for 3360 psi (230 bars) in Cold Water Conditions
• Increased Cold Water Efficiency by 50% Over Previous MK2 Regulator
• New Design:Proprietary Insulating Coating On-Key Internal ComponentsSpecific Anti-Freezing MeasurePatented Finned CapXtreme Thermal Insulating System (XTIS)Ribs of XTIS: Act as Radiator, Increase Surface Area of Heat TransferWarms-Up Internal Parts
• New Parts:Bigger Body and Cap ThreadsInsulating BushingSpring Isolation CoatingLarger Opening-On-CapRemovable OrificeInternal Parts Fully Insulated to Dramatically Improve Cold Water Performance